mirror of
https://github.com/tildearrow/furnace.git
synced 2024-12-05 10:47:26 +00:00
1.3 KiB
1.3 KiB
X1-010 instrument editor
X1-010 instrument editor contains three tabs: Sample, Wavetable and Macros.
Sample
for sample settings, see the Sample instrument editor.
the only differences are the lack of an "Use wavetable" option, and the presence of a "Use sample" one.
there also is a "Sample bank slot" setting, but I think that does nothing for now.
Wavetable
this allows you to enable and configure the Furnace wavetable synthesizer. see this page for more information.
Macros
- Volume: volume levels sequence.
- Arpeggio: pitch sequence.
- Waveform: waveform selection sequence.
- Panning (left): output level for left channel.
- Panning (right): output level for right channel.
- Pitch: fine pitch.
- Envelope Mode: sets up envelope. the way it works is kind of complicated and even I don't understand how it works, so it's not documented for now.
- Envelope: specifies which wavetable should be used for envelope.
- AutoEnv Num: sets the envelope to the channel's frequency multiplied by numerator.
- AutoEnv Den: sets the envelope to the channel's frequency divided by denominator.
- the X1-010 hardware envelope is considerably slower than AY's. beware!
- these two must be set in order for AutoEnv to work!