mirror of
https://github.com/tildearrow/furnace.git
synced 2024-11-30 00:13:03 +00:00
47 lines
2.6 KiB
Markdown
47 lines
2.6 KiB
Markdown
# Commodore Amiga
|
|
|
|
a computer with a desktop OS, lifelike graphics and 4 channels of PCM sound in 1985? no way!
|
|
|
|
in this very computer music trackers were born...
|
|
|
|
imported MOD files use this chip, and will set A-4 tuning to 436.
|
|
|
|
## amplitude/period modulation
|
|
|
|
Amiga has support for (rather primitive) amplitude and period (frequency) modulation.
|
|
however, nobody has used this feature as it is rather useless, not well-documented and works in a complicated way.
|
|
|
|
Amiga sample playback is done by two chips: Paula (the one that you probably know) and Agnus (the one that actually feeds Paula with samples).
|
|
Agnus has several DMA (direct memory access) units which read from chip memory independent of the CPU. four of these DMA units are used for samples.
|
|
|
|
when DMA is enabled, Paula requests sample data from Agnus, and then plays these samples back.
|
|
there's a catch though. since the data bus is 16-bit, Paula requests **two** 8-bit samples at once! this explains why:
|
|
- the sample length registers are in words rather than bytes (thereby allowing samples up to 131070 in length)
|
|
- the maximum playback rate (31250Hz PAL; ~31469Hz NTSC) is two times the HBlank rate (Agnus fetches samples on HBlank, around 15625Hz on PAL or ~15734Hz on NTSC)
|
|
|
|
during normal sample playback, the first sample is output and then the second. afterwards, two more samples are fetched, and so on.
|
|
|
|
now, when amplitude or period modulation are enabled, things work differently.
|
|
the channel is silenced, and the two 8-bit samples are **treated as a big-endian 16-bit number**, which is then written to the next channel's volume or period.
|
|
|
|
in the case of amplitude modulation, only the second sample is significant because the volume register uses 7 bits (to represent 0 to 64 (65 to 127 are treated as 64)) and the other bits are ignored.
|
|
|
|
in the case of period modulation, both samples are significant. the first sample is the upper byte, and the second is the lower byte.
|
|
|
|
## effects
|
|
|
|
- `10xx`: **toggle low-pass filter.** `0` turns it off and `1` turns it on.
|
|
- `11xx`: **toggle amplitude modulation with the next channel.**
|
|
- does not work on the last channel.
|
|
- `12xx`: **toggle period (frequency) modulation with the next channel.**
|
|
- does not work on the last channel.
|
|
- `13xx`: **change wave.**
|
|
- only works when "Mode" is set to "Wavetable" in the instrument.
|
|
|
|
## info
|
|
|
|
this chip uses the [Generic Sample](../4-instrument/sample.md) instrument editor.
|
|
|
|
- the maximum rate for sample playback is technically 31469Hz but anything higher than 28867Hz will sound glitchy on hardware.
|
|
- sample lengths and loop will be set to an even number.
|
|
- samples can't be longer than 131070.
|