furnace/papers/doc/7-systems/c64.md

58 lines
2.2 KiB
Markdown
Raw Normal View History

2022-01-16 06:10:43 +00:00
# Commodore 64
a home computer with a synthesizer-grade sound chip of which people took decades to master.
very popular in Europe and mostly due to the demoscene, which stretched the machine's limbs to no end.
# effects
- `10xx`: change wave. the following values are accepted:
- `00`: nothing
- `01`: triangle
- `02`: saw
- `03`: triangle and saw
- `04`: pulse
- `05`: pulse and triangle
- `06`: pulse and saw
- `07`: pulse and triangle and saw
- `08`: noise
- `11xx`: set coarse cutoff. `xx` may be a value between 00 to 64.
- **this effect only exists for compatibility reasons, and its use is discouraged.**
- use effect `4xxx` instead.
- `12xx`: set coarse duty cycle. `xx` may be a value between 00 to 64.
- **this effect only exists for compatibility reasons, and its use is discouraged.**
- use effect `3xxx` instead.
- `13xx`: set resonance. `xx` may be a value between 00 and 0F.
- `14xx`: set filter mode. the following values are accepted:
- `00`: filter off
- `01`: low pass
- `02`: band pass
- `03`: low+band pass
- `04`: high pass
- `05`: band reject/stop/notch
- `06`: high+band pass
- `07`: all pass
- `15xx`: set envelope reset time.
- this is the amount of ticks the channel turns off before a note occurs in order to reset the envelope safely.
- if `xx` is 0 or higher than the song speed, the envelope will not reset.
- `1Axx`: disable envelope reset for this channel.
- `1Bxy`: reset cutoff:
- if `x` is not 0: on new note
- if `y` is not 0: now
- this effect is not necessary if the instrument's cutoff macro is absolute.
- `1Cxy`: reset duty cycle:
- if `x` is not 0: on new note
- if `y` is not 0: now
- this effect is not necessary if the instrument's duty macro is absolute.
- `1Exy`: change additional parameters.
- `x` may be one of the following:
- `0`: attack (`y` from 0 to F)
- `1`: decay (`y` from 0 to F)
- `2`: sustain (`y` from 0 to F)
- `3`: release (`y` from 0 to F)
- `4`: ring modulation (`y` is 0 or 1)
- `5`: oscillator sync (`y` is 0 or 1)
- `6`: disable channel 3 (`y` is 0 or 1)
- `3xxx`: set duty cycle. `xxx` range is 000-FFF
- `4xxx`: set cutoff. `xxx` range is 000-7FF.